Replace the memory back-up battery ... it's probably dead and you
are losing the configuration each time you remove power.
73,
... Joe, W4TV
On 9/10/2011 4:02 PM, cx...@4email.net wrote:
> Hello,
>
> I have been away for 3 months. The K3 was completely disconnected from
> antennas, power supply, including removing the PP from the back of the rig.
> Today I decided to update the firmware and when I turned the power on, I
> got err BP1, then LPF, IO3, IF1, XV3, AT3, PA1, and BP3. After that, it
> worked fine. I hooked it up to dummy load and got full power on all
> bands...turned it off, same result, BP1, LPF, etc. I could use any of
> the rocker switches/buttons on the front panel and any of them would
> cycle to next error msg, in the same order as the first time..then work
> ok. I had an older firmware so decided to put 4.39 in the radio, along
> with the DSP1/DSP2. AFter the successful download, same thing....power
> up....BP1, LPF, etc.
>
> Any ideas, suggestions?
>
> 73
> Tom
> CX7TT
> P.S. K3 #250, factory built...3 times back to the factory, so far....
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft@mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
