Hi Jim My recollection is that the fuses need to be very firmly seated otherwise there is a problem as you indicate. I had a sismilar issue until I realised.
Regards Barry Simpson VK2BJ On 16 September 2011 02:39, <k2z...@aol.com> wrote: > Hi, > > > I just received my factory built KPA-500 amplifier. The fuses were not > included with the amp so I went to Radio Shack and picked up two 3 AG 6 amp > fuses for 240 v operation. > With the fuses installed the fuse block door will not close. Is this > normal? With the fuses out of the fuse block the door closes perfectly but > with the fuses installed I just can't close it. > > > Any suggestions? > > > Thanks, > Jim Douglas K2ZF > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html