The IC command will give you what you want. Voice VOX status is available in bit 6 of Byte d.
Jack B, W6FB On Nov 23, 2011, at 12:17 PM, tomb18 wrote: > I am attempting to use CAT commands to program the K3 to go into > something I > call remote or local mode (using HRD with macros assigned to buttons) > > Basically, remote mode switches the MIC to Line in and sets the > compression > to 0. What is missing is to set PTT. > > Local mode, switches MIC to front panel and sets compression to 15. > What is > missing is to set VOX. > > Now I can use the SWH09 command but this is a toggle. It works, but > if I > was to inadvertently press one Remote or Local twice in a row, then > the VOX > gets switched again and this will lead to an indeterminate state > where I > won't know what is happening. As I am using the SignaLink USB > interface, it > uses hardware PTT and this can occur when VOX is enabled, which may > cause > some issues. > > Now, it seems that the VX command is only a Get. Can anyone suggest > a work > around? > > Thanks > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/CAT-command-of-K3-VOX-tp7025990p7025990.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html