Isn't that why such filtering is usually done by "humungous" filter capacitors?
That would be my first choice to investigate. 73, Ron AC7AC -----Original Message----- Ed, Using a large filter choke in a relatively low voltage supply is difficult because of the voltage drop across the choke - and that voltage drop will change with current draw changes - so instead of improving the regulation, it will actually worsen. The problem is in the size wire used to wind the choke. In other words, a 25 volt drop at 3000 volts is a drop in the bucket, but even a 10 volt drop at 50 volts is likely to be too much. 73, Don W3FPR On 2/5/2012 12:54 PM, Edward R. Cole wrote: > Recent discussion of use of a filter choke with a battery powered K3 > prompts my question in another application. I have a 50vdc 50amp > switching PS which will power a 1100w sspa. Output filtering may be > needed to suppress switching impulses on the 50vdc output. I have a > large filter choke that was used in a 3000v PS which is probably at > least 5-8Hy. Do I need a bleeder resistor across it for protecting > circuits when powering off the switching PS? Or is using the large > filter choke not a good idea at all. What size filter chokes would > be recommended? The 50v PS is a HP PS intended for telephone industry (51v). > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
