Thanks Don and to all who responded.
Brian KB1VBF ----- Original Message ----- From: "Don Wilhelm" <w3...@embarqmail.com> To: "b denley" <b.den...@comcast.net> Cc: Elecraft@mailman.qth.net Sent: Thursday, February 16, 2012 1:49:28 PM Subject: Re: [Elecraft] K2: KAT2 Assembly Measure at U4 pin 1. 73, Don W3FPR On 2/16/2012 1:31 PM, b.den...@comcast.net wrote: > > I am assembling the KAT2 auto tuner. Everything is going OK but I am having > trouble with the following statement: > > > > > 'On the bottom of the KAT2 control board, locate a pad labeled "B". Just to > the left of this pad you'll > see the round pad for pin 1 of U4 (LM358). (You'll know you have the right > round pad if it's part of a group > of 8 pads, 7 of which are square.) Touch your DMM's (+) probe to this pad. > Connect your DMM's (-) probe > to any ground point on the K2.' > > > > > > > > Touch the probe to which pad? T he one labeled 'B' or the little round one > next to it? > > > > Anyone? > > > > Thanks > > Brian KB1VBF > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html