Thanks to everyone for the suggestions and help... As Don pointed out the IF gain decreases with an increase in voltage. I set the voltage at a point where there is no difference in the background noise with AGC on and off and the sensitivity is better....I built the little Elecraft generator a few minutes ago that I had been putting off for months.... :) The new K2 shows SO-9 in the 50 micro position and the old one does too... AGC threshold voltage is only 3.30v now though, but everything seems to be working fine... I guess that won't be a problem.. thanks again Tim Nz8J ----- Original Message ----- From: "NZ8J" <[EMAIL PROTECTED]> To: <elecraft@mailman.qth.net> Sent: Monday, July 25, 2005 12:57 PM Subject: [Elecraft] AGC Threshold voltage?
> The overall receiver gain of the K2 I just built (serial number 4993) seems > low as compared with my older serial number 315 K2. > > The max AGC threshold voltage I can get is 3.82 volts. (3.8 is what is > called for in alignment and Test Part I), but the troubleshooting section > says you can increase the voltage to increase the overall no-signal IF gain > and that a typical setting might be 3.9 volts. Mine is maxed out at 3.8... > does this sound correct? > > Thanks > Tim > Nz8J > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com