Good morning, I'm building a new K1-4 (sn. 3091) and I have completed the RF-Board part I. My building experience il reported in my association forum http://www.arilecce.it/index.php?option=com_kunena&func=view&catid=18&id=399&limit=6&limitstart=18&Itemid=94 http://www.arilecce.it/index.php?option=com_kunena&func=view&catid=18&id=399&limit=6&limitstart=18&Itemid=94
It seems everything is working well as I have successfully completed receiver alignment procedure. Now I'm going to find S-meter zero point following the steps described on page 53 of manual. After disconnecting the antenna, the S-meter still indicate a full scale signal (all bars are on). This happen for any value of Lxx and I'm wondering if something in my test is wrong or this problem hides a mistake in my building procedure. I also found a current consumption (on receiving) of about 35 mA that is a bit lower than the expected 55mA. Could it be another problem? I hope you can help me. Best regards. 73', IW7DMH Enzo -- View this message in context: http://elecraft.365791.n2.nabble.com/K1-4-Can-t-find-S-meter-zero-point-tp7426412p7426412.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html