Rob, Just as another wild guess - I need to ask if the IF frequency you are attempting to transmit on is lower than 28 MHz? (i.e. are you attempting to transmit CW below 50 MHz?) If so, that would place the signal outside the ham band and the K2 may have no output at that frequency (the firmware controls that feature). Try using CW at the same frequency that you are successfully transmitting SSB.
73, Don W3FPR > -----Original Message----- > > TRN1 option is set to On and I can see when setting TRN1 to off > the 6 meter > transverter switches off and 6 meter is not a selectable band anymore. > > Tried 10 meter CW and gives 100 watt output, no problem. > > CW is not in test mode but in oper mode > > Tried CW keyer in hand mode and dash side of keyer produces a cw tone, > release is switched on but no power, switching to SSB and it give 15 or 20 > watts output. The tuner indication switches from hi to low when selecting > the 6 meter transverter, although the connection cable is going > to the tuner > the antenna goes directly from K2 to Transverter and from transverter to > antenna. > > Unfortunately I haven't got a dummy load but can say for 99.9% I > am sure no > power goes out. > > Hope some others have bright ideas or can confirm their 6 meter > transverter > IS working on CW. At least I than know it can work. > > 73 Rob PA2R > > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.338 / Virus Database: 267.10.10/73 - Release Date: 8/15/2005 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
