Steve, The display used for the KX3 is the same as that used for the K3 - and the K3 has up to 5 roofing filters while the KX3 has only 3, but since yours does not have the roofing filter option, you have only one filter available and that is FL1.
The DSP sets the actual filter width and center frequency, and is quite good even without the additional assist from the roofing filters. I am just curious how you are able to select FL2 or FL3 without the KXFL3 installed. Have you checked the menu for RX XFIL and be certain it is set to Not Inst if you do not have the KXFL3 installed. 73, Don W3FPR On 7/12/2012 8:14 PM, Steve KC8QVO wrote: > I plugged an antenna in to my KX3 this evening for the first time - dead. I > got to playing around with it and cranked the filter wide open and the > receiver came back to life. > > Every time I crank the knob past Fil1 to Fil2 I loose the receiver. I > flipped through the manual and didn't see much pertaining to this. > > I am thinking that the roofing filters are just that - roofing filters. I do > not have them installed. Shouldn't the receiver allow DSP filtering down to > 50Hz? I see there are spaces for Fil4 and Fil5 on the display, but mine > don't light up past Fil3 even if I go down to 50Hz. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
