Keith, You can download the assembly manual for the K3 from http://www.elecraft.com/K2_Manual_Download_Page.htm#K3 and open up the rig and check for errors. It's tedious, but not difficult. Or take it back to uncle Elmer and make him do it.
73, Mike NF4L On 10/19/12 3:12 AM, Ham Radio wrote: > I embarked on a project to move parts from one K3 to another and I got the > rigs back from my tech elmer tonight. After getting the K3s home, I decided > to follow the procedure to get them operating again. > > I had my tech elmer transfer the KAT3, KRX3, KDVR3 and KBF3 from one of the > K3 to the other. I now have multiple errors and not sure what is going on. > The first receiver works well and I loaded the filters fine. However, when I > went to load the second receiver and run the synthesizer calibration I > received multiple errors. > > E020202 & E027979 - ERR DSE > E00005 ERR VCO > E000255 ERR VC4 > ERR PL2 > > When I went to install the DSP2 using the utility program I received these > errors. > > DSP 2 verification error > Error code OXE20000046 > > > I reviewed the manual and it says that I have a DSP Echo. The VCO and VC4 > error may suggest my friend installed the cables incorrectly. Pretty bummed > right now. Any additional thoughts would be very welcome. > > Thanks, > > Keith > AG6AZ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html