Hi Keith, You should review the KRX3 assembly/installation manual. There's a resistor that may need to be modified (see page 21) and maybe some other stuff as well.
73, Mike K2MK Keith Heimbold wrote > I have sent my Elmer tech friend a couple emails asking him if he swapped > out the other boards. If he did not, we will have to get that done and see > if the errors are eradicated. This is a set back for sure but it gives me > an opportunity to better understand the K3 and its component parts. > > I will also contact tech support to see what is going on with the error > codes. It appears that I also received a ERR DVR error code to top it off > after I sent the email to the reflector. > > Keith > AG6AZ > > Sent from my iPhone please excuse typos > > On Oct 19, 2012, at 5:07 AM, "Don Wilhelm" < > w3fpr@ > > wrote: > >> Was the DSP2 board and the synthesizer board for the KRX3 transferred >> from the other K3. From the errors you are getting, it would seem that >> they were not. >> >> Did your tech elmer just do the unplugging/replugging job or did he check >> the result out after each option was transferred? What did he say when >> you asked him for his observations. >> >> You may have to contact Elecraft support with your error codes. >> >> 73, >> Don W3FPR -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-Parts-transfer-between-rigs-tp7564314p7564329.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
