Jim.. This was not exactly the issue, but it was enough to point me in the right direction. This was an issue with N1MM, not the mode control but also a combination of N1MM, the Remote Rig and the keying methodology leveraging the remote rigs virtual com ports.. settings that appear to stick with the remote rig untill its restarted despite shutting down N1MM so a little tricky to work through. Anyway the short of the story is that it was an N1MM/Remote rig combination issue. I think we will be able to figure it out from here.
thanks to all who responded, and thanks Jim for offering the clue. This is very exciting and looking forward to essentially being back on the air from the Home QTH! ~Chris N6WM -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Jim Brown Sent: Monday, December 17, 2012 11:28 AM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] K3/0 to K3/100 twin issue at K6LRG On 12/17/2012 9:12 AM, Chris Tate - N6WM wrote: > Looking for some suggestions from the elecraft brain trust on this one Check the setup of N1MM -- the Mode tab, I think it's called. Depending on which box is checked, it can put the radio in the wrong mode. 73, Jim K9YC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html