John
Is D3 oriented correctly? Is it well soldered?
Is C2 well soldered?
Those two components are about the only ones that would prevent the
frequency from changing.
A faulty D3 is a possibility, although that would be rare.
73,
Don W3FPR
On 2/23/2013 9:43 PM, W8DE wrote:
I'm at the VFO range test in building of my K1. I go into the CAL menu,
display OSC and see a freq of 3.121 MHz. The frequency does not change when
I turn the VFO tuning pot.
I checked the voltage on the VFO POT signal and it goes between 0v and
5.935v. The voltage on D3 goes between 0v and 5.888v.
Any suggestions on where I should look to determine why I cannot change VFO
frequency ?
73,
John W8DE
--
View this message in context:
http://elecraft.365791.n2.nabble.com/K1-VFO-frequency-does-not-change-tp7570276.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html