For the record, my SVGA was on all the time. Cheers - Bill, AE6JV
On 3/5/13 at 12:41 AM, eastbrantw...@gmail.com (Stephen Prior) wrote: > It took me three attempts, failing on the SVGA load the first two times, > even after switching both K3 and P3 off and then on. > > I don't know whether this is significant but I had the SVGA disabled (I > have no monitor connected at the moment) the first two times but then > decided to turn it back on and the SVGA loaded okay - it could have been > coincicidence of course. I had similar issues last upload as well which is > very much in contrast to the troublefree uploads I have done on the K3 and > KX3 over the years. > > 73 Stephen G4SJP > > > On 5 March 2013 06:03, Bill Frantz <fra...@pwpconsult.com> wrote: > > > I just finished upgrading my P3 to MCU 1.26, SVGA 1.16 and FPGAx 1.04. The > > MCU loaded OK but then it rejected the SVGA. I followed the instructions to > > power cycle the P3 (and K3 since that was the closest P3 power switch). I > > tried a full reload ("Send all Firmware to P3") and it hung again. I power > > cycled it again, with a count to 10 while off and used "Send All New > > Firmware to P3" and it worked. > > > > MacOS 10.7.5 > > Elecraft USB <--> RS232 adapter > > P3 utility 1.12.10.4 (Mac version) > > > > Cheers - Bill, AE6JV > > ----------------------------------------------------------------------- Bill Frantz | gets() remains as a monument | Periwinkle (408)356-8506 | to C's continuing support of | 16345 Englewood Ave www.pwpconsult.com | buffer overruns. | Los Gatos, CA 95032 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html