-----Original Message----- I want to remove the KPA100 from my K2 and install it in the KAT100-2 enclosure. Since I will NOT be using any type of computer control, is it still necessary to install a KIO2 in the K2 and beef up the handling capacity of the RF choke? ------ I am running my KPA100/KAT100 from my K2 without a KIO2. I have installed a 9 pin connector in the K2 and connected only the necessary lines from the K2 control board. It is described in http://www.ac6rm.net/mailarchive/html/elecraft-list/2005-02/msg00041.html
See also the list of modifications on http://www.qslnet.de/member/la3za/K2/mod.html go to General mods and press KPA100/KAT100 where this mod and other related ones are linked. Good luck and 73 Sverre LA3ZA http://www.qslnet.de/la3za/ _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com