Jack,
The most common cause for that condition is that the connector blades
have not been inserted into the APP body far enough.
Look at the end of the connector assembly - if you can see the tip of
the spring finger under the contact blade, then the blade has not been
fully seated - give it a push with a small screwdriver and it should
snap into place.
A properly constructed APP connector takes about 10 pounds of force to
remove it.
73,
Don W3FPR
On 6/24/2013 8:26 AM, G8DX wrote:
Hi
Just finished building the basic K3 (sub rx and 100w PA awaiting installation).
Total build time was about 10 leisurely hours spread over a week. Throughout
the entire build I have only found one small issue which I find remarkable!
Hats off to Elecraft.
Anyway, my issue is the Anderson power connector doesn't firmly latch onto the
connector on the rig. It fits on and powers the rig but pulls off very easily.
Have I installed it incorrectly maybe?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
