Anyone have any problems with the new Firmware. I installed the firmware
updates on the K3, KPA500, and KAT500 tuner. I had problems with the K3
after the update. There was some kind of problem with the power output.
For starters I could not adjust the power out while the rig was keyed.
For instance I tried to adjust the power on my KPA500 from 250 watts to
500 and could not adjust it while keying it. If I unkeyed I could raise
the power a bit on the K3, then key back up to see what the AMP output
was, then unkey to adjust again, then key to check again.
I installed the older version of firmware back on the K3 and all was
well again.
--
73
Steve AI9T
http://www.ai9t.com
AI9T DX Cluster
Version 4 AI9T Telnet: dxc.ai9t.com port 7300
Version 6 AI9T-2 Telnet: dxc.ai9t.com port 7373 (CW + Skimmer)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html