Hi,
I've been trying for the last four days to figure out what is wrong with my
rig. I'm at Phase 2 Test and Alignment and got to testing the frequency of
the VCO. It had a reading of 00000. Also the voltage on R30 was 7.87V.
This is consistent with the VCO not oscillating. The reference oscillator
works fine and was within the expected ranges when I looked at it. What I
was able to notice was that U4 on the RF board has two pins with voltage
values that are out of spec. Pin 1 has 0.9V and pin 13 has 0V. If I read
the table they should be 2.1 and 4V respectively. It also seems that the 0V
on pin 13 is causing a 0V reading on pin 6 of U6. Otherwise U6 is in spec.
I got out my oscilloscope and got a Vrms of 1.13V on U4 pin 1. There wasn't
anything on pins 3 or 6 of U3. The voltages for Q17, Q16, and Q18 are as
follows:
Q17 E: 0V
B: 7.13V
C: 0.08V
Q16 E: 0V
B: 0V
C: 7.13V
Q18 G: 0.08V
S: 6.64V
D: 0V
I have been measuring and testing voltages and components for the last four
days and have run out of things to look at for the moment. If any of you
can help me with what my problem is, I would be most grateful.
Sincerely,
Joseph
KI4ITG
--
View this message in context:
http://elecraft.365791.n2.nabble.com/K2-VCO-Not-Oscillating-tp7588086.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
