A fellow ham is having the following problem withhis K2:
A year ago, we installed the KPA100 which worked fine until recently.
Suddenly, the TX Power Control failed and the K2 will deliver either
9-15 W or - with the 100W PA switched on - up to 150 W into a dummy load.
I suspect there is an issue with the TX-ALC, but no defective diode was
found.
I personally don't own a K2 but is there a TX gain calibration procedure
similar to the K3?
Suggestions welcome - thanks in advance.
73
Richard - HB9ANM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
