OK. I'm hoping someone has seen this before I start tearing into things
(and tearing my hair out).
My K2 started to lose power yesterday. Within an hour, the output
dropped to close to zero (1mW on 160m, 40mW on 10m). There are no signs
of distress or burning odors.
I checked the ALC... pinned at 5v. Everything looks good in terms of
levels/frequencies thru the XMIT mixer and filters, except the rf levels
are higher than indicated in the manual. I suspect this is due to the
ALC being wide open.
The dc levels for Q5, Q6, and Q7-8 bases are normal, and the resistance
checks on Q7-8 are OK. 8T looks fine. But the rf levels are all
considerably high, and look pretty ratty except on 10m. The rig draws
about 600ma in xmit.
Anyone seen this before?
Larry N8LP
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com