Be sure you are talking Apples and Apples here. There may be an Orange in the mix!
The responses you've gotten for calabrating your SWR to match the external meters are assuming you are putting your tuner in bypass mode. You didn't say that, and may not be doing so. What you said was "press[] TUNE". The K2 SWR meter will normally read the SWR between the Radio and the Tuner. Your external meters will read the SWR between the Tuner and the Antenna. There may be nothing wrong at all. Dan / WG4S / K2 #2456 <snip> You might want to adjust the KPA100's R26 and R27 to agree with your external meters. </snip> <snip> > When SWR is measured using a MFJ 962 tuner, a Daiwa 101N meter, a Bird > 43, Autek RF-1, or a MFJ 249 analyzer, the indicated SWR is always higher > than that shown on the K2. > > For example, pressing TUNE on the K2 may indicate a 1.0:1, but the other > meters all consistently indicate a value significantly higher - lets > say 1.4:1 </snip> _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com