Gene,
Only a possible guess.
You could try a direct Frequency Entry to a frequency in the 2 meter band.
Do it once with VFO A selected and then swap VFOs (A/B button) and do it
to that VFO as well.
73,
Don W3FPR
On 8/16/2014 5:21 PM, Gene Sochor wrote:
I just completed the straightforward install of my new KX3-2M 2-meter
module in my KX3 s/n 335 with ATU, encountering no issues. (firmware
level at 2.12). The simple configuration setup procedure also went
smoothly. After powering off and on as instructed, however, instead
of a new 144 MHz band, I have now added a band which VFOA says is 22.0
MHz, and VFOB is showing 44.0 MHz instead of 144.0. Restored the
various settings as they were before the install, powered off and on
again, then redid the 2 meter settings, with the same results. Has
anybody else experienced this, or have suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com