Nick, Read that paragraph with the undertanding that the most important shared circuits are the PLL Reference oscillator, the VCO, and the BFO stages - and they are also measured with the RF Probe even for receiver testing - the VCO and BFO should also be tested for correct frequency using CAL FCTR. Yes, the Bandpass filters, T/R switch, and Low Pass Filters are also shared, but they will be tested with a signal 'the other way 'round' during the steps indicated under Transmit Signal Tracing.
73, Don W3FPR > -----Original Message----- > > do the Transmitter Signal Tracing steps detailed in the Troubleshooting > > Appendix of the K2 manual. > > That seems to involve testing RX first, because of the shared circuitry, > which unfortunately seems to require 0.14V from a signal generator, and > my only signal generator is the Elecraft XG1, producing 50uV. :-( > > Is it possible/sensible to test the shared circuits the other way > 'round, whilst transmitting into DL1? > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com