Hi Dave, Check out the K2 manual, page 32, right hand column. Sounds like you need to loosen the set screws on the knob and push it in a bit tighter against the felt washer and then retighten the set screws. The felt washer acts as a friction brake and the amount of "braking force" depends on how much pressure is applied between the knob and the felt pad.
I've found that a mobile rig that I have which may have a similar construction the knob spins much more freely during hot summertime temperatures while in the winter it seems quite a bit more stiff. 73, Mark, NK8Q K2 #4786 >From: Dave Sublette <[EMAIL PROTECTED]> >Date: Wed Jan 04 08:39:25 CST 2006 >To: Elecraft <elecraft@mailman.qth.net> >Subject: [Elecraft] Haunted K2 >If this is a duplicate, I appologize, but I posted it 18 hours ago and >it hasn't appeared. Is there some delay built into this relector?? > > > >Good afternoon, > >Now that I have your attention, I don't really think that my K2 is >haunted, but it does seem to want to tune itself. > >As I tune the knob up and down the bands and come to the frequency that >I want to listen or transmit on, I stop turning the knob and I take my >hand off. The knob is fully stopped when I do this. As I watch the >readout after taking my hand off, the frequency starts to change slowly, >sometimes adding (or subtracting) as much as 80 hz to the frequency at >which I stopped the knob. The knob is actually turning by itself. It >may go either direction and seems not to be correlated to whichever >direction of rotation I was using when I stopped turning. > >I have been using the K2 regularly on the HF bands only for the past few >weeks. Since building the unit last spring, I have used it mainly as an >IF rig on the microwave bands. Until the last day or two, I haven't >noticed the "self tuning" feature. > >Perhaps this phenominom has been previously noted and a fix found. I >cheerfully admit that I haven't done any research in the Elecraft Archives. > >So....what say ye about this? > >Dave, K4TO > >_______________________________________________ >Elecraft mailing list >Post to: Elecraft@mailman.qth.net >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com