If you can get a desoldering tool with heated pencil and desolder vacuum
built-in
go for it. I got a Hako 808 and removed many remove components from
boards without damaging components or boards on any PCB's. Double-sided,
singles and multi-layer.
73,
KI4HRN
----- Original Message ----
From: Steve Kavanagh <[EMAIL PROTECTED]>
To: elecraft@mailman.qth.net
Sent: Wednesday, January 04, 2006 2:17:27 PM
Subject: [Elecraft] Relay Removal ?
OK, while everyone seems to be on the subject of
stupidity...I just found I installed two of Elecraft's
ubiquitous latching relays incorrectly (after several
checks to make sure it was done right !).
Has anyone ever successfully unsoldered one without
serious damage to either the relay or the board ? If
so what technique did you use ?
73,
Steve VE3SMA
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
