I did a poor job on describing the noise level jump. If I switch to ANT2, the 2nd rec. level goes WAAAY up.
73, Mike NF4L > On Feb 2, 2015, at 7:38 AM, Mike Reublin NF4L <n...@comcast.net> wrote: > > This morning I noticed something strange with #3539. On 80 & 160, tune only > put out 10W. The level is set for 44W. Full output is 44W, power set to 100W. > SWR with the AT in bypass is 1.3 on 80M, 1.2 on 160M. All this on ANT1. Power > out on 40M & up is as expected. > > I connected a dummy load to ANT2, and while screwing the connector on, there > was a huge jump in the volume level on the 2nd receiver. The selected antenna > is still ANT1. This condition is for all bands. The main receiver performs as > expected, when ANT2 is selected, noise goes down. > > 73, Mike NF4L > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to n...@comcast.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com