I just updated the K3 firmware to 5.10 since I am about to order the new
synth board. When I restarted the radio after the upload, the following
problem occurred:
When I press the TUNE button, the radio shows about 8 watts of power.
If I turn the power control up, the display defaults back to 8 watts.
In the config menu I have the tune power set to 20 watts.
I reloaded the firmware to make sure there wasn't a glitch in the
loading. The same problem still occurs.
The only other troubleshooting I did was to change the TX ALC (in the
config menu) to "OFF" When I tune up with the TX ALC off, I can get
full power out from the radio, so I assume that I do not have a
component failure problem.
Has anyone experienced this or know of any settings which I may have
inadvertently changed?
73 de K6SBA
David in Santa Barbara, CA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
