The Rounding YES/NO doesn't seem to have any effect. What should I be seeing? 2.5Khz is the highest value I can set.
On Mon, Nov 16, 2015 at 8:28 PM, Don Wilhelm <w3...@embarqmail.com> wrote: > Peter, > > I assume you are talking about the KX3. > It is already there - look at the VFO CRS description on the manual (see > page 40). Note that this is a per mode setting. No firmware change is > necessary. > > The K3 (and K3S) has something similar but uses the RIT knob if CONFIG: > VFO OFS is set to ON and both RIT and XIT are OFF. > > I use that regularly on both my K3 and KX3. > > 73, > Don W3FPR > > > On 11/16/2015 8:13 PM, Peter Pauly wrote: > >> One of the few things I miss from my Kenwood TS-590S is the Multi/CH knob >> that lets you change the VFO frequency up or down 5 KHz for each encoder >> transition. I used this all the time to go quickly to a frequency within a >> band. It was even usually faster than the manual keypad entry. >> >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com