Jim Rodenkirch wrote > > I'm not sure I understand......are you saying with the ATU removed the > VSWR is 1.2:1 and with it > > installed but not tuned it's 1.8:1 until the ATU "kicks in and does its > job???
Hi Jim, Sorry for the confusion. I'll pull everything into this post to put it in the correct context: Problem: 6M band -> VSWR 1.8:1 (KX3 meter) on 50ohm load connected directly to ant connector (no cable). ATU - bypass mode Load verified good. All other bands good. ATU will match to 1:1 if enabled and tune requested. After ATU match, 25ohm load yields 2:1 (KX3 VSWR meter test - OK). So the issue was that the ATU in bypass mode on 6M into good load gives a 1.8:1 VSWR. Working with Elecraft support, I removed the ATU board to check VSWR w/o the ATU in the line. That checked good 1.2:1. The ATU in bypass mode on 6M does not quite function as a 50 ohm transmission line. For my particular unit, it was higher than expected. 1.4:1 is considered OK. If the ATU is enabled and tune is engaged, it has no problem matching the output stage to the load and delivering rated power. So, operationally not really an issue. Just leave the ATU enabled and tuned. The reason for going into bypass mode was to perform a TX gain cal procedure, which specifies the ATU must be set to bypass. I used the KX3 utility to do this and it sets the ATU to bypass and steps thru each band. When it got to 6M, it failed - probably because the foldback circuit was kicking in @ 1.8:1 and/or the output stage can't deliver the 6 watts need to complete the cal into that mismatch. Doing the cal manually with the ATU on and matched for 6M band works fine. Hopefully, this provides a more useful note for anyone else that may have a similar issue. Trying to contribute back to the list - as I have learned a lot using this resource. Steve WD4SDC -- View this message in context: http://elecraft.365791.n2.nabble.com/KX3-VSWR-problem-tp7608809p7610821.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com