Hi Kevin,
Try removing each end of the IQ cable between the KX3 and PX3 and firmly
re-inserting it. What you are seeing usually is the result of one end not being
fully inserted in the jack, leaving one of the IQ lines open.
Eric
/elecraft.com/
On 1/10/2016 4:42 AM, kevino z wrote:
Not sure if it was the loading of the new KX3 firmware, or if I changed some
settings, but now on my PX3 panadapter, I see everything symmetrically mirrored
around the center. So for example, If there is a signal at Center frequency
-50kHz, it appears at +50kHz too. As I move the VFO, the signals eventually
converge and pass through the middle on their way to the ends of the
display.Anyone have any idea how to fix this, or what I did to get in this
mess?thank you -Kevin (KK4YEL)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to eric.swa...@elecraft.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
