The PC speaker is connected to the PC's internal sound card. For data
modes you said you are using the USB codec in the KIO3B, which is not
connected to the PC speaker. Try using a speaker connected to the K3's
SPKR output (or the internal speaker) to monitor the audio instead.
You can adjust the volume of received sounds using the AF control; it
shouldn't have any effect on the audio level in the codec (that should
be controlled by CONFIG:LIN OUT). You can also adjust the level of
monitored transmitted sounds using the K3's MON control, again without
impact on the actual transmit audio level (4-5 bars on the AGC meter,
adjusted using the LINE IN gain control).
73,
Rich VE3KI
W4RKS wrote:
Using a K3
KIO3 B (The new board)
"Y" cable connected to P3 via the RS232/P3 connection
USB cable from the K3 USB to a Windows 7 (32) PC USB port
The P3/Config RS232 is set to "USB"
Using Ham Radio Deluxe (HRD) Version 6.3.0.450
The PC shows "USB Audio Codec" for Transmit and Receive.
CAT control works. I can control the radio and the changes
show on HRD - from the HRD screen, I can change K3.
I see waterfall changes on HRD
PROBLEM: I hear NO AUDIO on the PC speaker. (Except, in
the DM/780 program of HRD - if I select the Voice synthesizer,
I do hear that voice in the PC speaker.)
I understand the control and audio functions are done through
the USB port / cable.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
