I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
A little homework reveals that this as a known side effect of changing
the passband shift from its default.
I'm sure I must have changed the PB CTRL to .01 at some point, but I
can't seem to change it back; a firmware reload didn't help. Moving VFO
A while in config:PB CTRL gives "N/A".
Note that this is only manifesting itself on SSB (all other modes are
set to the default of .05, and selecting hi/lo / shift/width works FB).
S/N 7080, old synths
versions before/after firmware reload:
5.38 1.25 2.86 2.86 1.03
--
73,
Jeff KC9WSJ
@ EN52wf
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com