1. Not possible. The two sensors feed into an electronic switch that
connects one sensor at a time to the microprocessor/LED bargraph display.
2. See the "W2 Owners Manual Rev D2", available on the Elecraft website.
On page 5, "Important note" #5, it describes how to put the W2 into
"search" mode. The W2 will automatically connect to the sensor getting
RF. I wouldn't recommend allowing *both* sensors to be hot; CW or SSB
will cause the sensors to switch rapidly and the resulting display would
be meaningless.
73,
Brian, W6FVI
On 2/23/2016 7:18 AM, Chris Tate - N6WM wrote:
I have installed a number of W2 watt meters in a large contest station in the
bay area. In general this has worked out real well, but now that I am setting
up a second SO2R position I need to ask if anyone has either written some
software or if it is at all possible to
1. Observe data from both sensor 1 and 2 at the same time
2. Switch without manual intervention (pressing the button) between
sensor 1 and 2.
If anyone has an intuitive solution to this so I don't have to move to 2
physical watt meters it would be great.
Apologies if this has been discussed at some point in the past.
Thanks
Chris
N6WM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to w6...@sbcglobal.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com