I picked up the Leo Bodnar frequency reference and a K3EXREF board after
reading a couple of threads here. I Installed the board according to
instructions, took static precautions, am using a known good cable from
the K3 to said reference. I can clearly hear the 10MHz tone on my K3
when I tune a VFO to 10MHz and the signal goes away if I disconnect the
coax from the freq reference. I've checked all of the tmp connectors
and reseated the K3EXREF board on the K3REF board and all pins are
properly engaged. But still no * on the display and the REF CAL setting
remains unlocked.
Am I missing something, is there something to do to enable the K3EXREF
other than plug in the freq reference and wait for some magic to happen?
73, Tighe NK4I
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
