Try this, worked for me <http://montac.com/images/antenna/UHF_2_N.jpg>
On 03/05/2016 11:57 PM, Nr4c wrote: > Link doesn't work for me. > > Sent from my iPhone > ...nr4c. bill > > >> On Mar 6, 2016, at 12:03 AM, Clay Autery <caut...@montac.com> wrote: >> >> Not to open a can-o-worms again, but just closing the loop here. A while >> back, I asked for help IDing the pins used on the pigtails soldered to >> the ANT1 & ANT 2 panel connectors. >> >> Well, I finally got my hands on some new ones, AND I have ID'd the EXACT >> part number should I ever need it again. I took a break from building >> my delta loop's third support tilt-base for about an hour today and >> finally built up the new N-connector panel mounts with pigtails. >> Now, I can put the OEM Elecraft parts away UN-molested and have them >> readily available should I ever need them. >> >> Here's a link to a pic with my newly constructed assemblies in the front >> and the OEM assemblies in the back: >> >> *http://montac.com/images/antenna/UHF_2_N.jpg* (2.15 MB file)* >> * >> _Notes on construction:_ >> N-Connector, panel mount - Pasternack Part# PE45085 >> Wire: 18 AWG, Mil-Spec, AG-Plated, Stranded Cu, BLACK, Teflon Jacket >> Pin: MILL-MAX 3231 PCB pin >> Solder: Pb/Sn/Ag/Cu (4% silver) >> >> Soldered using high temp, broad tip for fast heat, minimum dwell. >> After fully cooling, cleaned well with 99.9% Iso. Alcohol, dried. >> Resistance check done and measures below instruments resolution at zero. >> Exposed areas of wire/solder covered with 2-coats of conformal coating >> to prevent oxidation. >> >> Connectors installed and radio re-assembled. (Note: PA must be removed >> and shield unfastened and moved a bit to remove KAT3A board to allow OE >> connector removal. Installation is reverse of removal.) Silver plated >> wire is stiffer than the OE wire and requires some gentle shaping to >> line the pins up with the receptacles on the KAT3A board. >> >> That's it... Back to finishing up my over-engineered tilt-base and >> telescoping, free-standing (mostly) 40' mast. I'll post some pics of >> that later if anyone is interested. >> >> Have a good evening! >> >> ______________________ >> Clay Autery, KG5LKV >> MONTAC Enterprises >> (318) 518-1389 >> -- /************************************************* * Amateur Radio Station AC0HY * * W. Paul Mills SN807 * * Assistant EC Alpha-1 ARES Shawnee/Wabunsee, KS * * President Kaw Valley Amateur Radio Club * *************************************************/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
