Michael,
Check and recheck the plugging of the TMP cables. Make sure the TMP
connectors are fully seated. The cables must match that shown in Figure
12 on page 16 of the installation instructions.
Did you exit the menu after turning Tech Mode on? If not, you need to
do that and try again.
If no luck, contact Elecraft support for additional help and resolution.
73,
Don W3FPR
On 10/8/2016 4:18 PM, Michael via Elecraft wrote:
I just installed the new KSYN3a and when I turn on my K3/100/2M rig it does
not seem
to recognize the board. With "TECHMD ON" and pressing the display button
and rotating VFO B knob I
do not see SYN1 in the VFO B part of the display!
Also there is no LED light coming on - on the KSYN3a board at all.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
