Hi Michael, To be fully seated, the "wings" on the plugs must be right down against the "collar" on the socket. Having one of those TMP cable ends not fully seated in the socket is a very common malaise, sometimes with an intermittent contact, which is really fun to chase.
When it's right, there won't be even 1/16 inch between the wings and the collar. Good Luck & 73 Guy , K2AV On Sat, Oct 8, 2016 at 4:44 PM, Don Wilhelm <donw...@embarqmail.com> wrote: > Michael, > > Check and recheck the plugging of the TMP cables. Make sure the TMP > connectors are fully seated. The cables must match that shown in Figure 12 > on page 16 of the installation instructions. > > Did you exit the menu after turning Tech Mode on? If not, you need to do > that and try again. > > If no luck, contact Elecraft support for additional help and resolution. > > 73, > Don W3FPR > > On 10/8/2016 4:18 PM, Michael via Elecraft wrote: > >> I just installed the new KSYN3a and when I turn on my K3/100/2M rig it >> does >> not seem >> to recognize the board. With "TECHMD ON" and pressing the display button >> and rotating VFO B knob I >> do not see SYN1 in the VFO B part of the display! >> >> Also there is no LED light coming on - on the KSYN3a board at all. >> >> ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to k2av....@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
