Gerard, The PO; command displays actual output power. It will always respond with PO000; unless you're transmitting. See the PC; command for getting and setting the requested power output level.
At present there is no way to add a long delay to a macro. You could add a series of ;;;;; to add a short delay. With what other commands are you having a problem? David, W4SMT ________________________________ From: Gerard Elijzen <vk2...@icloud.com> To: elecraft@mailman.qth.net Sent: Saturday, October 29, 2016 11:57 PM Subject: [Elecraft] KX3 Macros commands Hi all, Just been playing with commands for the KX3 and found that when using the KX3 Utility on my MacBook Pro, that some commands don’t get a return. For example: PO; always returns P0000 despite that the power has been set at 10W. There are others as well which do not return anything after issuing a command to the KX3. I am only just starting to look into the possibilities with Macros and I hope to make a Macro which will do (roughly) the following: 1. CW mode 2. set Power 100mW 3. sent message 1 4. Pause 10 seconds 5. set Power 1W 6. sent message 2 7. Pause 10 seconds 8. set Power 5W 9. sent message 3 10. go back to 2 or exit Not sure if “a Pause can be done”. Newbie here and just starting, testing and reading up with the KX3 commands. Cheers Gerard VK2JNG ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
