Jamie,
You say the K3 is "bricked", however, the most common problem is that
the computer hiccuped during a firmware load.
The Display says MCU LD and the TX light is blinking.
If that is your condition, read the instructions for "Forcing A Firmware
Load" in the K3 manual or in the K3 Utility Help file (Troubleshooting).
73,
Don W3FPR
On 3/18/2017 11:29 AM, Jamie WW3S wrote:
trying to load new firmware......if I read Fred manual correctly, power on
while holding “SHIFT/LO/0” should reset it but its not working......the
SHIFT/LO/0 is that the knob for the width? I’m assuming it is, but mine doesn’t
say the zero.....
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
