Jamie: First install the most recent version of the K3 Utility from our web page at http://www.elecraft.com/K3/k3_software.htm. It's verison 1.16.7.25.
There are step-by-step instructions in K3 Utility Help, troubleshooting, MCU load failure, that will walk you through the recovery steps. 73 de Dick, K6KR -----Original Message----- From: Elecraft [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Jamie WW3S Sent: Saturday, March 18, 2017 08:29 To: elecraft@mailman.qth.net Subject: [Elecraft] bricked my K3 trying to load new firmware......if I read Fred manual correctly, power on while holding “SHIFT/LO/0” should reset it but its not working......the SHIFT/LO/0 is that the knob for the width? I’m assuming it is, but mine doesn’t say the zero..... ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to d...@elecraft.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
