Also make sure TMP connectors to and from synthesizer/KREF/Subrx boards
are secure.
Brian/K3KO
On 5/4/2017 13:46 PM, Don Wilhelm wrote:
Olaf,
The relays used by Elecraft are quite reliable, so I suspect that is not
a reasonable source of the problem. In more than 12 years of repairing
the Elecraft legacy gear (more than 1200 repairs), I have had to replace
only a small handful of relays due to failure. I have replaced several
where the builder has distorted the case with a soldering iron.
I would double and triple check the SUBIN and SUBOUT connectors. A
connector failure is much more likely than a relay failure.
You might contact K3support to see if they have encountered a situation
like yours before.
73,
Don W3FPR
On 5/4/2017 3:31 AM, la3rk wrote:
I have a K3 approx 8 years old. Fully equipped with subrx, 100W PA,
antenna
tuner and in/out module.
When I connect the subrx, the main rx sometimes loses signal and at
the same
time power out goes to zero.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to als...@comcast.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
