Alan,
Not having that amplifier, I cannot give you a positive answer, but I
can tell you how to determine if the BAND DATA outputs of the ACC
connector will band switch the amplifier.
What you need to look for is "band decoder" or something similar in the
amp manual. There may even be a chart of which codes will activate
which bands. Compare that with the chart of the coding on the BAND 0-3
outputs of the ACC pins. If they match, then all you have to do is make
up a cable to send the right bits to the amplifier.
73,
Don W3FPR
On 10/31/2017 4:50 PM, WA6KEK wrote:
Hi there,
Currently have my K3, P3, Steppir controller and PC working flawlessly via
the RS232 out on the K3 to the P3 then the Y cable to the Steppir and the
PC. Steppir follows logging program as does the K3 etc.
I just bought a Acom 600s and am not clear on how to best work it into my
connections so I get the auto band switching. I don't really want to use the
RF sensing method through the antenna cable.
Can the ACC port on the K3 be used to control the amp? I don't have anything
connected to that ACC port.
Thanks for any help!
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
