Steve,
I suspect that increasing the TX Delay will *not* fix that problem.
Since at greater than 50 watts, you hear relays clicking indicates that
the K3S COR is being activated.
The solution is to either move your RX antenna further from the TX
antenna or use some device that disconnects or grounds the RX antenna
while transmitting.
73,
Don W3FPR
On 11/13/2017 7:26 PM, Steve Steltzer via Elecraft wrote:
Here's the setup : 3 month old K3S. Full wave 80 mtr RX loop. Closest point to
TX antenna is around 200 ft. Over 50 watts I hear relays clicking and stations
have a hard time breaking in even using QRQ plus. I assume the RX antenna is
not switching fast enough and I'm gettingĀ milliseconds of high RF into the
front end and protection relays are kicking in???
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com