Stan,
If you use the 8 KHz receive offset, you can not use the roofing filter;
it is disables when you invoke the SHFT. So, having it will do you no
good. And, that's the simple answer.
I have my KX3 set to the offset as it cleans up the spectrum display
that I use; I've never looked into the performance difference of using
the offset or not. I did use my KX3 for causal DX, contesting, and
everything in between. It's a wonderful radio. I have since purchased a
K3s, so the KX3 has been relegated to Field Day use only.
Be careful of system sensitivity specs. Most receivers are more
sensitive than ambient conditions will allow. The .9 uV number you show
is absolutely fine for the lower end of HF, but you could use a little
more at the upper end. I live in an urban environment with power lines
and neighbors with noisy TVs, heat pumps, and solar arrays. I'd be more
than happy if I could use a sensitivity of a 1 uV on 80.
73,
Barry
K3NDM
------ Original Message ------
From: "stan levandowski" <sjl...@optonline.net>
To: Elecraft@mailman.qth.net
Sent: 1/29/2018 4:20:06 PM
Subject: [Elecraft] KX3 Roofing Filter Question
I am going to order another KX3 this week. Probably tomorrow. The last
one I ordered in 2012 did not have the roofing filter option and I do
not THINK I missed it.
I use ONLY CW and I do NOT contest. I like to CASUALLY chase DX and I
play in low stress sprints like NAQCC but mostly I just like to RAG
CHEW.
My antenna is an EFHW installed as a "half square" in trees at 30 feet
(MyAntennas 4010).
I have reviewed the Elecraft site notes, and done a fair amount of
Googling and I now am more confused than ever. It seems that the real
value lies in dealing with strong signals, crowded bands and ferocious
contesting conditions.
My bottom line question is this: If I DO NOT get the roofing filter
option will my KX3 receiver be LESS SENSITIVE? The Sherwood report
shows a pre-amp off sensitivity of .9 uv which improves to a very
impressive .09 with the preamp on. Is this somehow related to the
roofing filter?
I am especially concerned because I remember doing an A/B comparison on
a weak signal between my previous KX3 and my 55 year old Drake 2B and
the 2B beat the crap out of the factory built KX3. I can't help
wondering if the roofing filter I didn't buy in 2012 had something to
do with this.
I sure could use a real simple answer: buy it or don't buy it? CW
sensitivity is my ultimate goal because if I can't hear 'em I can't
work 'em.
Thanks and 73,
Stan WB2LQF
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k3...@comcast.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com