Hello Doug, My guess would be that the cable that should connect the P3 "RF IN" BNC to the K3 "IF OUT" BNC is either not fully-engaged on both ends, or is defective.
73, Dale - WA8SRA On Sat, May 26, 2018 at 4:52 PM, Doug Eaton via Elecraft < elecraft@mailman.qth.net> wrote: > Hello Elecrafters. I recently moved my station to a different room. > After setting everything up in the new location, everything works normally > except for the P3.. The P3 turns on and boots-up normally, but there are > no signals on the display. The frequency of the K3 is displayed correctly > on the top center of the display, so it seems that the cable is hooked-up > correctly, but the only signals on the display are random noise on the > bottom of the display at a level below S1. It doesn't change even if I > turn the antenna switch to a dummy load, or even shut the K3 off. I live > in town, and the local noise level is normally S9 or so on the lower bands, > but nothing shows on the display on any band, even though the K3 is > picking-up signals. Any ideas? Thanks es 73 de Doug N7QS. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to dmbor...@gmail.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
