No special configurations.   Make sure you have the correct antenna ports selected via the K3S and the KAT500.   And since the dummy load shows a high SWR, I would first suspect the coax jumper out of the radio to what ever is next in line.

73

Bob, K4TAX


On 12/3/2018 10:49 AM, Richard Hoffman, K1DJ via Elecraft wrote:
I put up my first 160 meter antenna last week in anticipation of participating 
in last weekend's contest.  I managed to get the antenna -- a slow slung 
inverted L with a single raised radial as a compromise on my tiny 100 by 100 
foot lot -- up in time.  I then managed to get the antenna down to an SWR of 2 
to 1 measured by a Rig Expert AA55 zoom analyzer, at the balun to which the 
raised wire and radial are directly attached, and ythen got the same 2.0 SWR 
reading at the shack end of a borrowed piece of about 50 feet of RG-213.  [I 
recognize that 2 to 1 is not perfect by any means, but it was certainly within 
the range of my Elecraft equipment, I thought.]

But then my K3S simply refused to tune or load into the antenna, either 
directly, using its internal ATU, or routed through my KPA-500 to a KAT-500 
tuner.  In both circumstances, the rig and/or tuner showed an SWR around 25 to 
1, and tuned at best to around 16 to 1, resulting in no apparent RF output.
After trying to fix this in various ways, I gave up on the 160M contest and 
turned to other pursuits, while seeking advice from several Elecraft-loving, 
160M-using, friends.

It finally dawned on me this morning to connect the rig to my dummy load.  The 
result of attempting to tune and load the dummy load is exactly the same as it 
was trying to use the new inverted-L:  initial 25 to 1 SWR, tunes down only to 
16.9 to 1.
The rig, amp, internal and external tuners, and dummy load work fine on 80M 
through 6M.  This is my first time trying them all on 160M.
QUESTION:  Are there special configuration or other steps I need to take to 
operate the K3S on 160 meters?  Do these symptoms suggest any other problems 
that you can help solve?

Please advise, and thanks!
73 -
Rich, K1DJScituate, MA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to rmcg...@blomand.net


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com

Reply via email to