Hi John, Would you elaborate as to why you want to have 500-2500hz as your audio passband width? I have my KX3 BW = 4.00 and run split mode with JS8Call and WSJT-X. That keeps my signal in the sweet spot and gives me a view to other signals up past 2500Hz in case I want to try to work them.
regards, Brian VE3IBW On Sun, Apr 28, 2019 at 6:41 AM John Newgas <g7...@newgas.net> wrote: > My KX3 is often operated remotely via a Raspberry Pi and VNC - mainly for > digital working with JS8Call and WSJT-X. > I’ve set up a set of programmed instructions that I run before each > session to make sure that everything is set up correctly such as Data Mode > A, Power Output, Microphone and Audio Settings. > > I can see how to set the Bandwidth (Passband Tuning ) using the BW Command > but I want to have a defined bandwidth of 500 to 2500 Hz, Is the right > way to use > BW 20 ; IS 1500 ; ? Or is there a better way to adjust the PassBand > offset ? > > John G7LTQ > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html