What is the power level set at? The level controls and alc adjustments set the modulation level, but in an Elecraft rig the power out is set by the power control. The other possibility is that the stations you are printing are running much more power than you are and/or may have a higher noise level than you are experiencing.
Jim Rhodes K0XU On Fri, Jun 14, 2019, 08:24 MaverickNH <cbjesse...@comcast.net> wrote: > I'll add that, with Win10 volume mixer sliders set at 50%, WSJT-X slider > set > to 50%, MIC GAIN is at 3-4 to get 4 bars with 5th flashing. Running Win10 > volume mixer slider to 100% does not allow 4-5 bars on the KX2 TX even with > MIC GAIN on 1 and WSJT-X slider near zero. > > BRET/N4SRN > > > > -- > Sent from: http://elecraft.365791.n2.nabble.com/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to jimk...@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com