Actually, it does. I reported on this in a message to the reflector titled "TX
Test Mode Garbage" dated 7-25-2017
As a follow up Wayne wrote:
Hi Wes,
TX TEST mode activates the entire TX strip because it turns on PTT to test the
keying of downstream devices. This was requested by our original field testers.
The only thing that isn’t turned on is the carrier. It could be that in SSB
modes there’s noise in the voice passband, producing the result you observed.
I can clarify this in an errata item for the owner’s manual.
It may also be possible for me to disable the TX AF path via a DSP command, and
I’ve added that to the firmware task list.
Thanks for the input--
Wayne"
Unfortunately, as I responded, I first observed it in CW mode, and I had at the
time, confirmation from three other guys who observed a similar situation.
Wes N7WS
On 8/26/2019 4:44 PM, Bob Wilson, N6TV wrote:
The K3 puts out no power when
in TX TEST mode, even if you have CW in SSB enabled and tap the key (which
you probably did at some point by going to CONFIG: CW WGHT and tapping [1]
to enabled it, which is useful in VHF bands it seems. You can disable the
feature if you don't want RF to come out or don't want the relay to close
while you're in SSB mode and accidentally tap the paddle.
73,
Bob, N6TV
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
