Go to the Config Menu and check BND MAP settings. This says you have
blocked or mapped 14.0 out. See page 58 of the manual.
73
Bob, K4TAX
On 11/12/2019 1:50 PM, Jim Danehy wrote:
I recently moved my K3, KPA 500 and KAT 500 to a new place in my home. It was
working perfectly before the move.
I hooked everything back up. All cables properly attached.
Now on 14.025 I get a tone every 7 seconds. Just a beep. It probably is 900
hertz. It comes like clockwork. It only does that on 14.025. It is a single
shirt burst,
Now when cycling through the bands using the KPA buttons it avoids 14 MHz.
I am looking for an explanation and assistance on how to correct the unwanted
short burst
73
W9VNE
Sent from my iPhone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to rmcg...@blomand.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com